Diseño de un esquema de reconección automática en alimentadores de distribución (Design of Automatic Reclosing scheme in distribution feeders)

Jorge Patricio Vasco Molina (jvasco@est.ups.edu.ec)1, Alexander Aguila Téllez (aaguila@ups.edu.ec)1


1Universidad Politécnica Salesiana

This paper appears in: Revista IEEE América Latina

Publication Date: Aug. 2015
Volume: 13,   Issue: 8 
ISSN: 1548-0992


Abstract:
This paper aims to serve as a document for the implementation of the system of reconnection in distribution feeders. Has become necessary in which to gather information about the failures raised in the specified evaluation period. The result would be to identify the number of failures that were cleared by the operation of the instantaneous overcurrent function in both phases and neutral primary feeders considered for undergraduate work. This could work on the design, to establish the number of reconnections that could have the feeder, the reconnection time it should have, that direct the type of equipment breakdown and the largest type of load served relationship. Part of the design is the intervention of control and protection circuits in each of the primary, in circuits opening, closing and locking. These must have a relationship with reclosing relay for the operation of reclosing. In different substations are installed relays IED, in this case it is necessary to intervene in the operating logic also enable reclosing function. In addition to link protection function whit reclosing relay. As in a SCADA system is important to re-build the communication parameters IEC 618 050 to have alarms on consoles operation control center, it is necessary to reconfigure the protocol and update the gateway, which no remote control operation is affected and work on par with reconnection function enabled.

Index Terms:
Protecction of distribution feeders, control scheme, fault in feeders, comunication, IEC 61850   


Documents that cite this document
This function is not implemented yet.


[PDF Full-Text (436)]